| |
| | |

Printer Forum   

 Forgot password?
 register
Search
View: 806|Reply: 2

How to clean the solenoid on samsung 4521f printer

[Copy link]

Post time: 2015-7-1 05:52:52 |Show all posts
I need to clean the solenoid on samsung 4521f printer (the Pickup Roller is turning over and overeach printing without stopping) and the printer takes more than 1 page at a time and makes a paper jam. I understand that I need to clean the solenoid but don't know how to disassemble this printer and get the solenoid out. how do i Exactly disassemble the printer and do it ? is there any video\pictures ON THIS PRINTER ?
thanks in advance

Post time: 2015-7-1 08:08:28 |Show all posts
I found 3 useful videos on youtube for you. First of all you don't need to remove the paper path frame. All you need is to gain access to the solenoid which is located at the right side of the machine (the left side if you're looking at the machine from the front).
Watch the first 1 minute and 45 sec of the first video for instruction on how to remove the rear and right panel of the machine.
https://www.youtube.com/watch?v=ZdViV_XtMIU
Then on the second video, the relevent bits are from 1 minute and 6 sec into the video. Ignore those before that as you only need to do those if you're going to remove the paper path frame. once you got the circuit board and the motor drive unit out, the solenoid is just right there behind.
https://www.youtube.com/watch?v=_MxHbh0xOa4
This third video is to show you how the solenoid should work. Each time the solenoid arm is pulled in and tehn releases, the white cam/gear turns one round. if the solenoid arm is stuck somehow, either because the foam has become sticky or the arm got stuck at the hinges (seen that before), the cam/gear will turn continuously causing continuous paper feed and eventually paper jam problem.
https://www.youtube.com/watch?v=5gTpCwj7Wds
Good luck.

Post time: 2015-7-1 07:06:17 |Show all posts
Never worked on this printer, but download the service manual at the link below and refer to 5-20. Shows how to remove the paper path frame and I am sure the solenoid is on the left side of the frame. You just clean the glue off the ledge that the "L" arm hits and put down new felt material and reassemble.
[url=]http://www.copyalbania.com[/url]
You have to log in before you can reply Login | register

Advertise on OASQ.COM| Contact us| Archive| OASQ

2019-8-24 13:21 GMT-8

Powered by Discuz! 7.2

Release 20121101, © 2001-2019 OASQ.

To Top