| |
| | |

Printer Forum   

 Forgot password?
 register
Search
View: 595|Reply: 3

How to clean Hp CM1312nfi printer

[Copy link]

Post time: 2012-6-6 22:56:13 |Show all posts
How to clean Hp CM1312nfi printer
--HEWLETT-PACKARD Cleaning Kit Maintenance Upgrade Kit for All Hp Designjet Printers

Post time: 2012-6-14 13:29:23 |Show all posts
It could be one of a few things, one being the yellow toner cartridge, try using a different cartridge after replacing the cartridge run several cleaning modes from the service menu.  If the problem is still persistent it could be the fuser assembly is too hot and therefore is scorching the paper or the etb is dirty. to clean the belt, access the secondary service menu, setup/press setup and cancel at the same time/ press set up again and you should see the secondary service menu/ select clean belt/ do this 5 times.
Al
Eliteprintersolutions@gmail.com

Post time: 2012-6-12 06:36:50 |Show all posts
if the printer has not been used for a while the other colours may have dried out..
try using cargtridge clean function on your printer to ensure all cartridge heads are clean.
I hope this was helpful.

Post time: 2012-6-9 16:33:12 |Show all posts
Try doing a hard or reset or nvram:
1. Turn the printer off, disconnect the phone line
2. Hold down the right arrow and the cancel button
3. Reboot the printer while holding the buttons and hold until permanent storage is displayed. Let go of the buttons and wait for the ready message on the display.
If the lcd does not display anything contact hp or a local service provider as there is a definite power failure.
Al
Eliteprintersolutions@gmail.com
You have to log in before you can reply Login | register

Advertise on OASQ.COM| Contact us| Archive| OASQ

2021-11-27 18:25 GMT-8

Powered by Discuz! 7.2

Release 20121101, © 2001-2021 OASQ.

To Top